|
Alldocube mini pro nfe only has two touch input
|
Technical Discussion
|
1
2568
|
|
Please try to turn off the three-finger screenshot function, and then check whether the multi-finger operation in the corresponding software is normal.
|
|
Bricked tablet save iplay50 (T1030)
|
Technical Discussion
|
3
2892
|
|
|
Open the device manager that comes with the Windows operating system. After the machine is shut down and you press and hold the volume down key to connect to the computer, there will be a new device in the device manager. If the driver is installed well, there will be a sprd port.
If there is no response at all in the device manager, check the connection problem.
|
|
Widevine L1
|
Technical Discussion
|
1
2056
|
|
|
Widevine L1 requires the operation of writing L1key. Non-L1 machines cannot directly become L1 machines.
|
|
GTbook 13 pro not charging
|
Technical Discussion
|
1
1825
|
|
|
You can try to enter the machine bios and reset the bios to the default settings. After the machine is shut down, press and hold the power button for 30 seconds or even more than 1 minute, and then try to completely cut off the power.
|
|
SUPPORT
|
Technical Discussion
|
2
2168
|
|
|
Due to design reasons, the type-c interface does not support simultaneous OTG and charging functions of the hub.
|
|
Superbox B02 – How to enter The Bios
|
Technical Discussion
|
1
1702
|
|
|
You can try to enter bios by pressing the ESC key on your keyboard when booting up.
|
|
Iplay 50 lcd replacement the same as samsung tab a7 screen?
|
Technical Discussion
|
1
2301
|
|
|
The screen parameters may be similar, but the actual screens are still different.
|
|
Cube iwork 10
|
Technical Discussion
|
1
1256
|
|
|
You need to provide the actual model and serial number of the machine, and then contact the email service@alldocube
|
|
cant enter to my window
|
General Discussion
|
1
1636
|
|
|
Provide the serial number of the machine. For this model, you can try to reinstall the Windows operating system using a USB disk.
|
|
i50 T1030 Factory Reset
|
Technical Discussion
|
1
8991
|
|
|
You can try pressing and holding the volume down button to turn on the phone. When the robot falls interface appears, press the power button + volume up button to enter recovery mode, and then execute the two options at the beginning of wipe to restore the machine to factory settings. (Different models of Spreadtrum machines may be different. You can also press and hold the power button for 3 seconds, then quickly press and hold the volume down button until the machine startup screen appears. Release the power button. When the robot falls to the ground interface appears, release the volume down button. button) After shutting down the machine, follow the above method and try pressing the button to enter recovery mode to reset the system.
|
